Rear A/C Receiver Drier - Removal

REMOVAL

WARNING: Review safety precautions and warnings before performing this procedure and . Failure to follow these instructions may result in serious or fatal injury.





1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the rear refrigerant system .
3. Remove the screws that secure the rear condenser cover to the top of the vehicle and remove the cover.
4. Disconnect the wire harness connector (6) from the rear A/C pressure transducer (2).
5. If required, remove the rear A/C pressure transducer.
6. Remove the bolts that secure the rear condenser outlet line (1) and the rear A/C liquid line (7) to the rear A/C receiver/drier.
7. Remove the two screws (5) that secure the rear A/C receiver/drier to the rear A/C condenser (4).
8. Disconnect the rear A/C receiver/drier from the rear A/C liquid line and the rear condenser outlet line and remove and discard the O-ring seals.
9. Install plugs in, or tape over the opened refrigerant line fittings and receiver/drier ports.