Clutch Keys & Springs

NOTE: The clutch hubs and sleeves are a selected assembly and should be kept together as originally assembled, but the keys and springs may be replaced separately.

1. Mark hub and sleeve so they can be matched upon reassembly.

2. Push hub from sliding sleeve and remove keys and springs.

3. Install the three keys and two springs so all three keys are engaged by both springs. The tanged end of each spring should be installed into different key cavities on either side. Slide sleeve onto hub, aligning marks made before disassembly.

NOTE: A groove around the outside of the hub identifies the end that must be opposite the fork slot in the sleeve when assembled. This groove indicates the end of the hub with a 0.070 inch greater recess depth.