Final Assembly

^ Tools Required:
- J 8092 Driver Handle
- J 23765 Axle Shaft Bearing Installer
- J 23771 Axle Shaft Seal Installer
- J 23911 Pinion Oil Seal Installer

INSTALL OR CONNECT





1. Bearing with J 23765 and J 8092 until the tool bottoms against the housing shoulder.
- Lubricate the bearing with axle lubricant.





2. Oil seal using J 23771 until it is flush with the axle tube.
- Lubricate the seal lips with axle lubricant.
3. Axle shafts into the axle housing.
- Be careful not to damage the oil seal.
- The splines at the end of the axle shaft must engage with the splines of the axle side gear.
4. The "C" locks on the axle shaft.





- Pull the axle shaft outward so the "C" lock seats in the counterbore of the axle side gear.
5. Pinion shaft through the case and the differential gears.
- Align the hole in the pinion shaft with the lock bolt hole.
6. Pinion shaft lock bolt.
- Tighten lock bolt to 34 Nm (25 ft. lbs.).
7. Cover gasket and cover.
- Tighten cover bolts to 27 Nm (20 ft. lbs.).
8. Lubricant to the axle.
- Lubricant to a level within 9.5 mm (3/8 inch) of the filler plug hole.
- Tighten fill plug to 35 Nm (26 ft. lbs.).