Component Tests and General Diagnostics

1. Check that ground G200 is clean and tight.
2. Check the GAUGES Fuse by observing the Instrument Cluster gages.
3. Check CIG LTR Fuse by operating the CIGAR LIGHTER.
4. Check condition of PWR ACC Circuit Breaker for an open condition. If breaker is open, locate arid repair source of overload.
5. Always check terminal contact before replacing any component.
6. If a second transmitter is available, try it. If it works, change the batteries in the first transmitter and try again. If it still doesn't work, it is defective.
7. Check Portable Transmitter battery terminals. They should be clean and make good contacts with the battery.
8. If in doubt as to the condition of the Transmitter batteries, replace them with new ones. Check battery voltage with a DVOM may give results. Refer to Section 9K for Remote Keyless Entry Module access and additional information. Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD' in continuity Voltage check (Refer "Troubleshooting Procedure"). Diagnostic Aids