Rear Housing Disassembly

^ Tools Required:
- Hydraulic Press
- J 36511 Oil Drain and Fill plug Hex Bit (17 mm)
- J 23907 Slide Hammer with Pilot Bearing Puller
- J 26941 2WD Output Shaft Oil Seal Remover

DISASSEMBLE





1. Rear housing shift shaft bearing, using J 23907 with pilot bearing puller.
A. Position puller legs behind bearing lip.
B. Tighten.
C. Slide hammer out.
- If the bearing lip breaks off, position puller legs behind the inside (outer end) bearing lip and repeat procedure.
2. Drive out dowel pins.





3. Slip yoke seal, using J 26941 and J 23907.
4. Gasket material from the case using liquid gasket remover.
5. Oil drain and fill plugs into the transmission case using J 36511.