Dome Lamp: Service and Repair

REMOVAL PROCEDURE
1. Press in on the sides of the lens.
2. Remove the lens.
3. Remove the bulb.
4. Remove the housing.
5. Disconnect the electrical connectors.
6. Squeeze the clip tangs together at each clip and push the clip connector up through the housing.

INSTALLATION PROCEDURE
1. Connect the electrical connectors to the housing.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the housing to the roof inner trim panel with 2 screws.

Tighten
Tighten the dome lamp housing screws to 2 N-m (18 lb in).

3. Install the bulb.
4. Install the lens.