87. Output Shaft Bushing Inspection

Output Shaft Bushing Inspection - 4WD





1. Inspect the output shaft bushing (2) for wear and damage.
2. Measure the Inside Diameter (ID) of the bushing (2) at dimension A.
3. Replace the bushing If the ID of the bushing exceeds specifications.

The maximum bushing ID is 20.07 mm (0.794 inch).
4. Measure the Outside Diameter (OD) of the bearing surface at dimension B.
5. Replace the output shaft if the OD of the bearing surface is less than specifications.

The minimum bearing surface OD is 44.978 mm (1.77 inch).