Vent Hose Connector Replacement

Vent Hose Connector Replacement - Front Drive Axle

Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.





2. Disconnect the vent hose from the vent hose connector.





3. Remove the vent hose connector from the differential carrier assembly.

Installation Procedure





1. Install the vent hose connector into the differential carrier assembly. Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent onto the threads.

2. Tighten the vent hose connector.
^ Tighten the vent hose connector to 28 Nm (21 lb ft).

Notice: Refer to Fastener Notice in Service Precautions.






3. Connect the vent hose to the vent hose connector.
4. Lower the vehicle.