Locking Differential Clutch Disc Assembly Assemble (8.6 Inch Axle)

Locking Differential Clutch Disc Assembly Assemble (8.6 Inch Axle)




1. Apply the correct axle lubricant to the surface of each disc. Refer to Adhesives, Fluids, Lubricants, and Sealers (Rear Drive Axle).
2. Assemble the right side or bell-end side clutch disc assembly as follows:

1. Install the two-sided carbon eared disc (2) to the side gear (1).
2. Install the 1st splined disc (4).
3. Install the 2nd splined disc (5).
4. Install the one-sided carbon eared disc (6).
5. Install the guide clips (3) to the clutch discs (2, 4-6).
Apply chassis grease to the guide clips in order to hold the clips in place on the disc ears. Refer to Adhesives, Fluids, Lubricants, and Sealers (Rear Drive Axle).