With A/C

Evaporator and Blower Assembly Component View:

Evaporator and Blower Case Replacement:

Control Assembly Replacement:

REMOVE OR DISCONNECT

1. Charge air cooler.

2. Negative battery cable.

3. Refrigerant from the system.

4. Electrical connections.

5. Refrigerant outlet line (109) from the accumulator (4).

- Cap or plug open lines.

6. Case flange screws (139) and nuts (147).

7. Blower case (140) with the accumulator (4).

IMPORTANT: Drain refrigerant oil from the accumulator into a clean container. Measure and add new oil.


INSTALL OR CONNECT

1. Blower case (140) with the accumulator (4).

IMPORTANT: Add 0.057 kg (2 oz.) of clean refrigerant oil PLUS an amount equal to that drained.

2. Refrigerant inlet line (108) to the accumulator (4).

IMPORTANT: Add 0.057 kg (2 oz.) of clean refrigerant oil PLUS an amount equal to that drained.

- Use clean 525 viscosity refrigerant oil on the seal.

- Tighten connector to 24 Nm (18 ft. lbs.).


3. Electrical connection (154).

4. Negative battery cable.

5. Charge air cooler.

6. Refrigerant to the system.

- Evacuate, charge and leak test.