Install or Connect

1. Throttle body assembly (2) with new flange gasket (1).

Notice: See "Service Precautions." Service Precautions

2. Throttle body attaching bolts (3).
Tighten
- Throttle body attaching bolts (3) to 24N.m (18ft.lb.).
3. Accelerator control, T.V., and cruise control cables.

Important:
- Make sure throttle and cruise control cables do not hold throttle open.

4. Vacuum lines.
5. Electrical connectors to TPS (5) and IAC (4).
- Reposition CAC and tighten bolts.
6. Negative battery terminal.
Inspect
- With the engine "OFF," check to see that the accelerator pedal is free.
- Depress pedal to the floor and release.

- Reset IAC valve pintle position:
a. Depress accelerator pedal slightly.
b. Start and run engine for five seconds.
c. turn ignition "OFF" for ten seconds.
d. Restart engine and check for proper idle operation.