Radiator: Service and Repair

1. Drain coolant from radiator.
2. Remove air intake snorkel.
3. Remove windshield washer reservoir.
4. Disconnect hood release cable.
5. Remove upper shroud.
6. Disconnect upper radiator hose.
7. Disconnect low coolant sensor.
8. Disconnect overflow hose from radiator.
9. Disconnect oil cooler lines, if required.
10. Raise and support vehicle.
11. Disconnect lower radiator hose from radiator.
12. Lower vehicle, then remove master cylinder from brake booster.
13. Remove radiator mounting panel, if required.
14. Remove radiator from vehicle.
15. Reverse procedure to install noting the following:
a. Following radiator cap installation, start engine and allow to run until upper radiator hose becomes hot (thermostat is open).
b. Add coolant with engine idling until coolant level reaches bottom of filler neck.
c. Install radiator cap. Ensure arrows are inline with overflow tube. Inspect for leaks.