Steering Column Housing Assembly

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- J 41396 Park Lock Cable Pliers
- Or Equivalents

REMOVAL
Remove or disconnect the following:
1. Do all installation steps, Refer to Coil Replacement.
2. Do steps 7 and 8, Refer to Turn Signal & Multi Function Switch.
3. Do steps 2 through 6, Refer to Linear Shift Assembly Replacement.
4. Do steps 2 through 6, Refer to Upper Column Housing Components Replacement.
5. Do steps 2 through 9, Refer to Lock Module Assembly.
6. Four TORX(R) head screws (9).
7. Steering column housing assembly (26).

INSTALLATION

CAUTION: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

Install or connect the following:
1. Steering column housing assembly (26).
2. Four TORX(R) head screws (9). Tighten (9) to 9.0 Nm (80 lb in).
3. Do steps 1 through 8, Refer to Lock Module Assembly.
4. Do steps 1 through 5, Refer to Upper Column Housing Components.
5. Do steps 1 through 5, Linear Shift Assembly Replacement.
6. Do all installation steps, Refer to Coil Replacement.