Washer

When the Washer Switch is depressed, voltage is supplied to the Solid-State Control Board in the Wiper Control Module. The Wiper Switch supplies battery voltage to the Washer Motor through CKT 392. It also starts the wiper cycle through the low speed brushes of the Wiper Motor. The washer continues to run as long as the switch is held down. The Solid-State Control Board keeps the wipers on for approximately six seconds after the washer goes off. If the washer is switched on during the PULSE operation, the wipers run in low speed for six seconds. When the wash cycle is completed me Wipers return to the pulse operation.

The Wiper Motor is equipped with a circuit breaker which protects the motor when the wipers are blocked. The resulting high current will open the circuit breaker which will reset upon cooling.