Gear Reduction and Drive Group

Gear Reduction And Drive Group:

Important
^ If the drive end bushing and plug are being replaced, install them in the drive housing.
^ Lubricate the drive end housing bushing, shift lever, and driveshaft as described in "Lubrication".

Gear Reduction And Drive Group:

INSTALL OR CONNECT
1. Arms on the shift lever with the shift collar onto the driveshaft and clutch group.
2. Assembled shift lever and driveshaft and clutch group into the drive housing.

Drive Shaft And Clutch Group:

A. Align the holes in the driveshaft support with those in the drive housing.
B. Make sure that the driveshaft support is fully seated in the drive housing and that the drive- shaft bearing remains fully seated in the drive- shaft support.
3. Shift lever screw, washer, and nut.
Tighten
^ Shift lever nut to 4.5 N.m (40 lb in).
4. Plate, if used, and drive housing plug to the drive housing.
5. Washers in the same number and position as noted at disassembly.
6. Armature support bracket to the drive housing.
^ Align the mark made prior to disassembly with that on the drive housing.
7. Drive housing bolts.
Tighten
^ Drive housing bolts to 8.5 N.m (75 lb in).