Rear Servo Assembly Band Apply Pin Check

REMOVE OR DISCONNECT





1. Rear servo assembly.

Measure
^ Tools Required:
- J 21370-10 Gage Pin
- J 38737 Band Apply Pin Checking Tool









1. Place J 21370-10 in the servo bore.
2. Position J 38737 over the bore with the hex nut facing the parking pawl linkage.
3. Fasten with the two rear servo cover bolts
- Tighten bolts to 24 Nm (18 ft. lbs.).
4. Ensure J 21370-10 moves freely in the tool and pin bore.
5. To determine the correct pin length, apply torque to the nut on the gage.
- Tighten nut to 34 Nm (25 ft. lbs.).





6. For pin selection, refer to the figure.