Oil Pressure Sensor Fitting Replacement

Oil Pressure Sensor Fitting:

Oil Pressure Sensor:

Remove or Disconnect

IMPORTANT
- Note the orientation of the oil pressure sensor fitting prior to removal.

1. Oil pressure sensor from fitting.
2. Fitting from block.

Install or Connect
1. Fitting to the block.

Tighten
- Fitting to 15 N.m (11 Lb. ft).

IMPORTANT
- Increase torque until fitting is properly aligned for the installation of the sensor.
- Do not rotate fitting more than 359 degrees after minimum torque has been met.
- Under no circumstances should the fitting be loosened to obtain rotational orientation.