Slip Ring End Frame

CS-144 Components (Part 1 Of 2):

Removing The Slip Ring End Bearing:

Slip Ring End Frame With Starter Removed:

Rectifier Bridge In End Frame:

REMOVE OR DISCONNECT
1. Three rectifier bridge to stator nuts.
2. Stator.
3. One screw from the brush holder and two insulated screws from the regulator connector.

Slip Ring End Frame With Starter Removed:

4. Brush holder, regulator, and connector from the end frame.

Rectifier Bridge In End Frame:

5. BAT terminal nut from the insulated heat sink.
6. Two screws and washers from the grounded heat sink.

Rectifier Bridge In End Frame:

7. Capacitor and rectifier bridge from the frame.
8. BAT terminal from the outside of the frame.