Inspection - 1998 Models Only

Important
Some early production 1998 vehicles were manufactured with an upper console plate (1) that does not have a round or D-shaped hole (3) located between the two square holes (2). In order to perform this campaign the vehicle MUST HAVE this additional hole (3) in the upper console plate.





1. Verify whether or not the vehicle has this additional hole by opening the console compartment cover and comparing the holes in the upper console plate to those shown in the illustration above.

- If the upper console plate DOES have the hole (3) located between the two square holes (2), proceed to the service procedure titled "Inner Console Cover Replacement".

- If the upper console plate does NOT have the hole (3) located between the two square holes (2), proceed to the service procedure titled "Upper Console Plate Replacement".