54. Forward Clutch Installation

^ Tools Required
- J 38358-A Forward Clutch Assembly Remover/Installer
- J 36850 Assembly Lubricant





1. Align the direct clutch plates in order to aid in the installation of the forward clutch assembly (602).

Important: Following installation of the forward clutch assembly (602), the distance between the top of the speed sensor ring and the pump gasket surface should be approximately 98-99 mm (3.85-3.89 inch).

2. Use the J 38358-A in order to install the forward clutch assembly (602).
3. Install the overdrive carrier thrust bearing (601) (silver side up) onto the forward clutch housing assembly (602). Retain with J 36850 or equivalent.