Operation CHARM: Car repair manuals for everyone.
Home >> GMC >> 2000 >> K 3500 Truck 4WD V8-6.5L DSL Turbo VIN F >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Service and Repair >> Overhaul >> 4L80-E/4L85-E Automatic Transmission >> Repair Instructions >> 93. 3RD/4TH Clutch Accumulator Housing Installation

93. 3RD/4TH Clutch Accumulator Housing Installation

^ Tools Required
- J 25025-5 Guide Pin





1. Install the J 25025-5 into the control valve body bolt hole where the manual shaft detent roller and spring assembly is mounted.
2. Install the control valve body gasket (45).
3. Install the control valve body spacer plate (46).





4. Install the accumulator housing gasket (47).
5. Install the 3rd clutch accumulator piston spring (50). This spring is the longer of the two accumulator springs.
6. Install the 4th clutch accumulator piston spring (49).
7. Install the 3rd and 4th clutch accumulator housing assembly (51) onto the control valve assembly (44).
8. Install the six 3rd and 4th clutch accumulator housing bolts (53). Start the bolts finger tight and work from one end of the accumulator housing towards the opposite end.





Notice: Refer to Fastener Notice in Service Precautions.

9. Tighten the 3rd and 4th clutch accumulator housing bolts (53) in the order shown.
^ Tighten the bolts to 11 Nm (97 inch lbs.).
10. Remove the J 25025-5.
pro multis · About Operation CHARM