Vehicle Speed Sensor: Service and Repair

Vehicle Speed Sensor (VSS) Replacement

Tools Required
^ J 38417 Speed Sensor Remover

Removal Procedure
1. Raise the vehicle.
2. Remove the harness connector.





3. Remove the bolt.
4. Place a drain pan under the vehicle.
5. Remove the vehicle speed sensor using J 38417.
6. Remove the O-ring seal.

Installation Procedure





1. Install the new speed sensor and O-ring seal using J 38417.
2. Coat the seal with a thin film of transmission fluid.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the bolt.
Tighten the bolt to 11 Nm (97 inch lbs.).
4. Install the harness connector.
5. Lower the vehicle.
6. Refill the fluid as required.