Operation CHARM: Car repair manuals for everyone.
Home >> GMC >> 2004 >> Canyon 4WD L4-2.8L VIN 8 >> Repair and Diagnosis >> Transmission and Drivetrain >> Transfer Case >> Service and Repair >> Transfer Case 2/4 Indicator Switch Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Transfer Case 2/4 Indicator Switch Replacement

Transfer Case 2/4 Indicator Switch Replacement

Removal Procedure





1. Raise and support the vehicle.
2. Disconnect the gray engine wiring harness electrical connector (2) from the gray 2/4 indicator switch electrical connector (4).





3. Disconnect the gray 2/4 indicator switch electrical connector (2) from the bracket (1).
4. Loosen the switch connector bracket bolt in order to release the 2/4 indicator switch pigtail.
5. Remove the transfer case 2/4 indicator switch (4) and gasket (3) from the transfer case.

Installation Procedure

Notice: Refer to Component Fastener Tightening Notice in Service Precautions.





1. Install the transfer case 2/4 indicator switch (4) and gasket (3) into the transfer case.
^ Tighten the 2/4 indicator switch to 39 Nm (29 ft. lbs.).
2. Route the 2/4 indicator switch pigtail along the bracket (1)
3. Install the switch connector bracket bolt.
^ Tighten the switch connector bracket bolt to 15 Nm (11 ft. lbs.).
4. Connect the gray 2/4 indicator switch electrical connector (2) to the bracket (1).





5. Connect the gray engine wiring harness electrical connector (2) to the gray 2/4 indicator switch electrical connector (4).
6. Lower the vehicle.
pro multis · About Operation CHARM