Window Replacement - Endgate

Window Replacement - Endgate

Removal Procedure

1. Lower the end gate window approximately halfway down.
2. Swing the end gate open.
3. Remove the end gate window outer sealing strip.
4. Remove the end gate trim panel.
5. Remove the inner reinforcement panel.




6. Disconnect the electrical connectors from the defogger grid on the window.
7. Remove the bolts (2) retaining the end gate window clips (1) to the regulator carrier plates.
8. Remove the window from the end gate.

Installation Procedure




1. Install the end gate window to the end gate. Ensure the window is engaged in the run channels.
2. Install the window clips (1) down onto the regulator carrier plates.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the bolts (2) retaining the window to the regulator carrier plates.

Tighten the window bolts to 12 N.m (106 lb in).

4. Connect the electrical connectors to the defogger grid on the end gate window.
5. Install the inner reinforcement panel.
6. Install the interior trim panel.
7. Install the end gate window outer sealing strip.