Carpet Replacement - Rear (Envoy XUV)
Carpet Replacement - Rear (Envoy XUV)
Removal Procedure
1. Remove the front seats.
2. Remove the rear seats.
3. Remove the front door sill plates.
4. Remove the rear door sill plates.
Notice: Remove the headliner and the headliner harness as an assembly. Do NOT cut or splice the headliner harness. Cutting or splicing the harness may damage the coax cable, resulting in poor radio performance.
5. Remove the center pillar trim panels.
6. Remove the rear floor trim panel.
7. Remove the left/right lower body lock pillar trim panel.
8. Remove the jack and tool stowage bracket.
9. Remove the rear seat & mid-gate rest.
10. Remove the body electrical block.
11. Remove the body electrical block electrical connectors back through the hole in the carpet.
12. Pull the communication interface module electrical connectors back through the hole in the carpet.
13. Remove the floor console to the floor console carrier.
14. Remove the 4 nuts (2) retaining the rear of the floor console bracket to the floor weld studs.
15. Raise the rear portion of the floor console bracket and remove the carpet from underneath the console bracket.
16. Remove the carpet from the vehicle.
Installation Procedure
Caution: In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material size as the original installation. Always return the carpet to the original location.
1. Position the carpet to the floor panel.
2. Raise the rear portion of the floor console bracket and slide the carpet underneath the console bracket.
3. Position the rear carpet over the edge of the front carpet.
4. Align the holes in the carpet to the seat studs on the floor panel.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the four nuts (2) retaining the rear of the floor console bracket to the floor weld studs.
Tighten the nuts to 25 N.m (18 lb ft).
6. Feed the bussed electrical center base and the communication interface module electrical connectors through the pass through holes in the carpet.
7. Install the floor console.
8. Install the center pillar trim panels.
9. Install the front side door sill plates.
10. Pass the communication interface module electrical connectors through the small hole in the carpet.
11. Pass the body electrical block electrical connectors through the small hole in the carpet.
12. Install the body electrical block.
13. Install the jack and tool stowage bracket.
14. Install the rear seat & mid-gate rest.
15. Install the left/right lower body lock pillar trim panel.
16. Install the rear floor trim panel.
17. Install the rear side door sill plates.
18. Install the rear seats.
19. Install the front seats.