88. Output Shaft Bushing Replacement
Output Shaft Bushing ReplacementTools Required
^ J43791 Output/Turbine Shaft Bushing Installer
^ J44526 Output/Turbine Shaft Bushing Remover
Removal Procedure
1. Install J44526-2 (8) and J44526-1 (7) Into the bushing (9).
2. Install J44526-2 (8) into J44526-1 (7)
3. Install the washer (6) and nut (5) onto J44526-2 (8).
4. Hold the top of J44526-2 (8) with a wrench and tighten the nut (5) until J44526-1 (7) engages the bushing (9).
5. Install the bearing (3), washer (2), and nut (1) onto J44526-2 (8).
6. Install J44526-3 (4) onto J44526-2 (8)
7. Hold the top of J44526-2 (8) with a wrench and tighten the nut (1) until the bushing is dislodged.
8. Remove the J tools.
9. Remove the bushing from J44526.
Installation Procedure
1. Install a new output shaft bushing (2) onto J43791 (1)
2. Using J43791, drive the bushing into the output shaft (3) until J43791 (1) is seated.
Make sure the bushing is pressed flush to 0.25 mm (0.01 inch) below the output shaft surface.