Solenoid C, D, E, F, G

Control Valve Solenoid Replacement (Solenoid C, D, E, F, G)

Removal Procedure
1. Remove the oil pan and suction filter.
2. Disconnect the internal wiring harness from the solenoid being changed.





3. Remove the solenoid retainer (1) for the C solenoid (3). Note the position of the solenoid connector and pull the solenoid (3) out of the bore in the control valve assembly. The O-rings (2) and (4) provide the resistance felt during removal.





4. Remove the solenoid retainers (6) for the D solenoid (1), E solenoid (4), F solenoid or solenoid (8), whichever is being replaced.
5. Note the position of the solenoid connector and pull the solenoid out of the bore in the control valve assembly. The O-rings (2) and (3) provide the resistance felt during removal.

Installation Procedure





1. Obtain a new D solenoid (1), E solenoid (4), F solenoid (1), or G solenoid (8). Install O-rings (2) and (3) and lubricate with clean transmission fluid. Push the new solenoid into the control valve assembly (5) with the wiring harness connector in the correct position.
2. Reinstall the solenoid retainer (6). Reconnect the internal wiring harness to the solenoid(s) replaced.





3. For new C solenoid (3), install O-rings (2) and (4) and lubricate with clean transmission fluid. Push the new C solenoid (3) into the control valve assembly with the wiring harness connector in the correct position. Reinstall the solenoid retainer (1).
4. Install the oil pan and suction filter.