Automatic Door Locks Inoperative

AUTOMATIC DOOR LOCKS INOPERATIVE

DIAGNOSTIC INSTRUCTIONS
- Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
- Review Strategy Based Diagnosis for an overview of the diagnostic approach.
- Diagnostic Procedure Instructions provides an overview of each diagnostic category.

CIRCUIT/SYSTEM DESCRIPTION
The automatic door lock feature can be programmed to control the door lock system. The automatic door lock feature is factory programmed to have all doors lock and unlock. When the automatic door lock feature is programmed to control the door lock system, the driver door switch, passenger door switch and body control module (BCM) will lock the vehicle doors when the ignition 1 input is ACTIVE, the door jam switch inputs are INACTIVE and the transaxle is not in PARK.

This automatic door lock function will only occur once per ignition cycle unless, a door jamb switch input changes state to active and back to inactive. Then the driver door module, passenger door module and BCM will lock all doors again.

Once the automatic door lock feature has locked the doors, the BCM will then unlock all the doors when the transaxle is shifted into PARK.
- Data Communication Connector End Views

CIRCUIT/SYSTEM VERIFICATION
Press the top and bottom of the door lock switch. All of the vehicle doors should lock and unlock.
- If one or more vehicle doors do not lock or unlock, refer to Power Door Locks Inoperative (RPO AXA) Power Door Locks Inoperative (With RPO Code AXA)
Power Door Locks Inoperative (RPO AXC/AXE). Power Door Locks Inoperative (RPO Code AXC/AXE)

CIRCUIT/SYSTEM TESTING
Follow the DIC Vehicle Personalization instructions outlined in the Owner's Manual.
- If the personalization options cannot be set, replace the BCM.

REPAIR INSTRUCTIONS
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for BCM replacement, setup and programming Programming and Relearning