Instrument Panel Upper Trim Panel Replacement
Instrument Panel Upper Trim Panel Replacement
Removal Procedure
1. If equipped with air conditioning (A/C), set the air flow control to the instrument panel (IP) vent position.
2. Apply the parking brake to prevent the vehicle from moving.
3. If the transmission is automatic, move the shift lever all the way down.
4. Tilt the steering wheel to the full down position.
5. Remove the IP cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
6. Remove the end panels. The left panel is shown, and the right panel is similar.
7. Remove the right side air outlets.
8. Remove the assist handle by depressing the release tabs accessed through the air outlet duct holes.
9. Remove the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement .
10. Remove the bolts retaining the panel to IP assembly.
11. Lift the trim panel up to disconnect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
12. Remove the trim panel from the IP assembly.
Installation Procedure
1. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
2. Install the trim panel to the IP assembly.
Notice: Refer to Fastener Notice .
3. Install the trim panel retaining screws.
Tighten the trim panel retaining screws to 2 N.m (18 lb in).
4. Install the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement .
5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
6. Install the right side air outlets.
7. Install the end panels. The left panel is shown, and the right panel is similar.
8. Install the IP cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
9. Tilt the steering wheel to the normal driving position.
10. If the transmission is automatic, move the shift lever to the park position.
11. Disengage the parking brake.