Relay Replacement - Within an Electrical Center
RELAY REPLACEMENT (WITHIN AN ELECTRICAL CENTER)
TOOLS REQUIRED
J 43244 Relay Puller Pliers
REMOVAL PROCEDURE
1. Remove the electrical center cover.
2. Locate the relay.
3. IMPORTANT:
- Always note the orientation of the relay.
- Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
Using the J 43244 (1) position the tool on opposing corners of the relay (2).
4. Remove the relay (2) from the electrical center.
NOTE: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
INSTALLATION PROCEDURE
1. Install the relay (2) in the same position as removed.
2. Install the electrical center cover.