Starter Motor: Service and Repair
Starter Motor Replacement (4.8L, 5.3L, and 6.0L Engines)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the engine oil level indicator tube fasteners and position aside.
3. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
4. Remove the right transmission cover bolt.
5. Remove the starter bolts.
6. Disconnect the oil level sensor electrical connector.
7. Slide the starter forward until the starter clears the transmission.
8. Remove the starter solenoid nut (3).
9. Remove the starter lead (2) from the solenoid stud.
10. Remove the starter lead nut.
11. Remove the positive cable from the starter stud.
12. Place the starter on a workbench.
13. Unsnap the transmission cover from the starter.
14. If necessary, remove the starter shield.
Installation Procedure
1. If necessary, install the starter shield.
2. Snap the transmission cover to the starter.
3. Install the positive cable to the starter stud.
Notice: Refer to Fastener Notice.
4. Install the starter lead nut.
Tighten the nut to 9 N.m (80 lb in).
5. Install the starter solenoid lead (2) to the solenoid stud.
6. Install the starter solenoid nut (3).
Tighten the nut to 3.4 N.m (30 lb in).
7. Snap the transmission cover onto the starter.
8. Slide the starter rearward.
9. Install the starter bolts.
Tighten the bolts to 50 N.m (37 lb ft).
10. Connect the oil level sensor electrical connector.
11. Install the right transmission cover bolt.
Tighten the bolt to 9 N.m (80 lb in).
12. Lower the vehicle.
13. Install the engine oil level indicator tube.
14. Connect the negative battery cable.