Stub Shaft Housing Replacement
Stub Shaft Housing Replacement (670 Gear)
Disassembly Procedure
1. Important:
Replace the housing if the stub shaft housing, seal or bearing are damaged.
Remove the stub shaft housing bolts (4) from the stub shaft housing (3).
2. Remove the stub shaft housing (3) from the steering gear.
3. Remove the stub shaft housing O-rings (1) (2) from the steering gear.
Assembly Procedure
1. Grease the stub shaft seal with the special grease supplied with the new stub shaft housing.
2. Install the new stub shaft housing O-rings (1, 2).
3. Install the stub shaft housing (3) onto the steering gear.
4. Notice:
Refer to Fastener Notice.
Install the stub shaft housing bolts (4) into the stub shaft housing (3).
Tighten the stub shaft housing bolts to 63 Nm (46 ft. lbs.).