Mirrors - Temperature Displays SC or OC

MIRRORS - TEMPERATURE DISPLAYS SC OR OC

DIAGNOSTIC FAULT INFORMATION
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

CIRCUIT/SYSTEM DESCRIPTION
The inside rearview mirror (ISRVM) applies 5 volts to the ambient air temperature sensor. The ambient air temperature sensor is a thermistor which varies in resistance as the temperature changes. As the resistance of the ambient air temperature sensor increases, the ISRVM senses a larger voltage drop across the sensor, indicating a lower temperature. As the resistance of the ambient air temperature sensor decreases, the ISRVM senses a smaller voltage drop across the sensor, indicating a higher temperature.

DIAGNOSTIC AIDS

Ambient Air Temperature Sensor Resistance:

The table will be used to measure the resistance of the sensor and compare it with the actual ambient temperature. The mirror's temperature accuracy should be within 5 degrees of the actual temperature. The actual temperature should not be taken from a radio station, a sign displaying the temperature, etc. A temperature measuring tool such as a thermometer should be used. Some temperature measuring tools may be within 5 degrees of the actual temperature. Make sure to consult the manufacturer for the accuracy of the tool. This comparison can make the mirror seem off by 5-10 degrees of the actual temperature when it is not.

CIRCUIT/SYSTEM TESTING
1. Ignition OFF, disconnect the ambient air temperature sensor.
2. Ignition OFF, test for less than 1 ohm of resistance between the low reference circuit and ground.
- If greater than 1 ohm, test the ground circuit for an open/high resistance.
3. Ignition ON, verify that OC is displayed on the ISRVM display.
- If OC is not displayed, test the signal circuit for a short to ground.
4. Ignition ON, install a 3-amp fused jumper wire between the signal circuit and ground. Verify that SC is displayed on the ISRVM display.
- If SC is not displayed, test the signal circuit for an open/high resistance. If the circuit tests normal replace the ISRVM.
5. If the display is correct, replace the ambient air temperature sensor.

REPAIR INSTRUCTIONS
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for ISRVM replacement, setup, and programming Programming and Relearning