Automatic Transmission Dipstick - Dipstick Tube: Service and Repair

Transmission Fluid Filler Tube and Seal Replacement

Removal Procedure




1. The transmission case has provisions that enable the fill tube to be installed on either the right or left side of the transmission. Proceed to step 9 if servicing the plug and/or seal opposite the fill tube.
2. Remove the transmission fluid level indicator.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
4. If equipped with 4WD, remove the front propeller shaft. Refer to Front Propeller Shaft Replacement Front Propeller Shaft Replacement.
5. Place a drain pan under the transmission to catch any fluid.




6. Remove the fill tube nut (1).
7. Loosen the fill tube from the transmission.
8. Remove the fill tube (2) and seal (3) from the vehicle.
9. Remove the right side transmission heat shield. Refer to Transmission Heat Shield Replacement Transmission Heat Shield Replacement.




10. Remove the fill tube plug (1).
11. Remove the fill tube plug seal (2).

Installation Procedure




1. Install a new fill tube plug seal (2) into the main housing.
2. Align the tab on the fill tube plug (1) with the tang on the main housing.
3. Install the fill tube plug (1). Press the plug into the seal (2) until the tab on the fill tube plug locks into place in the notch on the main housing.
4. Install the right side transmission heat shield. Refer to Transmission Heat Shield Replacement Transmission Heat Shield Replacement.




5. Install a NEW fill tube seal (3).
6. Install the fill tube (2). Ensure that the fill tube bracket is positioned properly on the stud.
Caution: Refer to Fastener Caution Fastener Caution.

7. Install the fill tube fastener (1) and tighten to 22 Nm (16 lb ft).
8. If equipped with 4WD, install the front propeller shaft. Refer to Front Propeller Shaft Replacement Front Propeller Shaft Replacement.
9. Lower the vehicle.
10. Fill the transmission to the proper level with approved fluid.