Crankshaft Rear Oil Seal and Housing Installation

Crankshaft Rear Oil Seal and Housing Installation

Special Tools

* EN-42183 - Handle

* EN-46109 - Guide Pin Set

* EN-47839 - Crankshaft Rear Oil Seal Installation Tool

For equivalent regional tools, refer to Special Tools Special Tools.





1. Install the 6 mm (0.236 in) guides from the EN-46109 - pin set into the 2 crankshaft rear oil seal housing corner bolt holes of the engine block.





2. Install the EN-47839 - tool with the EN-42183 - handle (1, 2) onto the rear of the crankshaft flange.





3. Place a 3 mm (0.118 in) bead of RTV sealant to the NEW crankshaft rear oil seal housing as shown (1). Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.





Note:
DO NOT allow any engine oil on the area where the crankshaft rear oil seal housing is to be installed.

4. Install the crankshaft rear oil seal housing to the engine block.





5. Remove the EN-46109 - pin set 6 mm (0.236 in) guides from the engine block.





6. Install the crankshaft rear oil seal housing bolts.





Caution:
Refer to Fastener Caution Fastener Caution.

7. Tighten the crankshaft rear oil seal housing bolts in sequence and tighten to 10 Nm (89 lb in).





8. Remove the EN-47839 - tool and EN-42183 - handle (1, 2) from the crankshaft flange.