Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously. (This is the last day we'll be asking)
Crankshaft Main Bearing
Loosely install the original inner main cap bolts.
Loosely install the NEW outer main cap bolts.
Loosely install the NEW short/inner side main cap bolts.
Loosely install the NEW long/outer side main cap bolts.
Tighten the main cap bolts using the EN 45059 - meterin the following sequence:
Tighten the inboard bolts (1-8) first, in two passes.
Tighten the inboard bolts to 20 Nm (15 lb ft) on the first pass.
Tighten the inboard bolts (1-8) an additional 80 degrees on the 2nd pass.
Tighten the outboard bolts (9-16) second, in two passes.
Tighten the outboard bolts to 15 Nm (11 lb ft) on the first pass.
Tighten the outboard bolts (9-16) an additional 110 degrees on the 2nd pass.
Tighten the short/inner bolts (17-20) third, in two passes.
Tighten the short/inner bolts to 30 Nm (22 lb ft) on the first pass.
Tighten the short/inner bolts (17-20) an additional 60 degrees on the 2nd pass.
Tighten the long/outer bolts (21-24) fourth, in two passes.
Tighten the long/outer bolts to 30 Nm (22 lb ft) on the first pass.
Tighten the long/outer bolts (21-24) an additional 60 degrees on the 2nd pass.
Ensure that the crankshaft turns without binding or noise.