Rear

Fig. 803 Rear Wheel Bearing & Speed Sensor Removal.:

1. Raise and support vehicle, then remove rear wheel and tire assembly.
2. Remove rear brake drum, then disconnect sensor electrical connector, Fig. 803.
3. Remove wheel bearing and sensor attaching nuts and bolts, then bearing and sensor assembly. After bolts are removed, the rear brake assembly will be held in place by the hydraulic pipe. Use care not to bump or exert any force on the brake assembly to prevent any damage to the hydraulic pipe.
4. Reverse procedure to install, noting the following:
a. Align bolt holes in wheel bearing and speed sensor assembly, drum brake assembly and rear suspension bracket.
b. When installing bolts, rotate axle flange to align large hole with each bolt location, then install bolt while holding nut.
c. Torque bolts to 37 ft. lbs.