Control Arm Bushing: Service and Repair

Fig. 7 Lower Control Arm Replacement:

Fig. 8 Cutting Flange From Control Arm Front Bushing:

Fig. 9 Rear Bushing To Control Arm Installation:

Fig. 10 Rear Bushing Positioning:

1. If control arm bushing are to be replaced, proceed as follows:
a. Remove lower control arm.
b. Press rear bushing from control arm, Fig. 7.
c. Cut flange off front bushing, then press front bushing from control arm, Fig. 8.
d. Apply soap and water to outer surface of front bushing, then press front bushing into control arm until it is centered.
e. Position rear bushing to control arm, then drive bushing into control arm, Figs. 9 and 10.
6. Reverse procedure to install.