Inspection

1. Note electronic settings before disconnecting negative battery cable from battery and wait a minimum of 90 seconds before proceeding.

2. Remove 2 screws securing center console to rear center console.

3. Remove tray liner and screws underneath tray liner.

4. Raise parking brake lever and remove console.

5. Remove 3 bolts securing console mounting bracket to floor. Remove bracket.





6. Remove connectors and check for ANY evidence of liquids, dried liquid residue or corrosion (See Figure 1);

A). On top of sensor

B). On sensor connector terminals

C). On connector terminals

D). On sensor mounting bracket.

7. If there is NO evidence of liquids, dried liquid residue or corrosion, reconnect the connectors and proceed to Vinyl Sheet Installation procedure in this bulletin. If there is ANY evidence of spilled liquids, proceed to Sensor Replacement and Connector Cleaning procedure in this bulletin.