Manual Transmission/Transaxle: Service and Repair

1. Disconnect battery ground cable.
2. Remove gear shift lever as follows:
a. Remove console cover.
b. Remove boot clamp and boot.
c. Remove gear shift lever by pushing down on lever, turning counterclockwise and then pulling up.
3. Raise and support vehicle.
4. Drain transmission fluid.
5. Mark then remove front and rear propeller shaft.
6. Disconnect speedometer cable.
7. Remove catalytic converter to frame bolts and bracket.
8. Support transmission using a suitable transmission jack.
9. Remove transmission crossmember.
10. Remove breather hose, back-up, fifth gear, connectors.
11. Disconnect clutch linkage and remove starter motor.
12. Remove flywheel inspection cover.
13. Remove transmission to engine bolts then lower transmission assembly.
14. Reverse procedure to install, tightening all fasteners to specifications.