F. Gearshift and Select Shaft Overhaul

REMOVE OR DISCONNECT
1. Reverse interlock shaft roll pin from gearshift and select shaft.
2. 5th and reverse gearshift cam from gearshift and select shaft.
3. 5th and reverse cam guide return spring from gearshift and select shaft.
4. Gearshift cam guide roll pin from gearshift and select shaft using a standard drift punch and hammer.
5. 5th and reverse gearshift cam guide from gearshift and select shaft.
6. Select spring guide and reverse select spring from gearshift and select shaft.
7. One washer and one C-clip from gearshift and select shaft.
8. 5th and reverse gearshift cam inner and outer roll pins from gearshift and select shaft using a standard drift punch and hammer.
9. Gearshift interlock plate and gearshift and select lever from gearshift and select shaft.
10. One C-clip and one washer from- gearshift and select shaft.
11. Low speed select spring and select spring guide from gearshift and select shaft.
12. One C-clip from gearshift and select shaft.

Clean
- All components with clean solvent and dry thoroughly.

Inspect
- All gearshift and select shaft parts for excessive wear or damage. Replace as necessary.

INSTALL OR CONNECT
1. One C-clip onto gearshift and select shaft.
2. Select spring guide and low speed select spring onto gearshift and select shaft.
3. One washer and one C-clip onto gearshift and select shaft.
4. Gearshift interlock plate and gearshift and select lever onto gearshift and select shaft.
5. 5th and reverse gearshift cam inner and outer roll pins into gearshift and select shaft using a standard drift punch and hammer.
6. One C-clip and one washer onto gearshift and select shaft.
7. Reverse select spring and select spring guide onto gearshift and select shaft.
8. 5th and reverse gearshift cam guide onto gearshift and select shaft.
9. Gearshift cam guide roll pin into gearshift and select shaft using a standard drift punch and hammer.
10. 5th and reverse cam guide return spring onto gearshift and select shaft.

Important
- When installing the 5th and reverse gearshift cam, load the 5th and reverse cam guide return spring by winding one half to one full turn.

11. 5th and reverse gearshift cam onto gearshift and select shaft.
12. Reverse interlock shaft roll pin into gearshift and select shaft using a standard drift punch and hammer.