Determining Selective Washer Thickness

^ Tool Required:
- J 23085 Selective Washer Gaging Tool

Measure
1. Install J 23085 on the case flange and against the input shaft (319).
2. Position the inner shaft of J 23085 against the thrust surface of the second clutch hub.
3. Tighten thumb screw. Remove J 23085.
4. Measure gap "A". Compare measurement "A" to the chart with pin gage or equivalent.
- Selective washer thickness must not exceed measurement "A".

ASSEMBLE

- Install the proper selective washer (224) onto the input shaft (319).