DTC 33-3x
DTC 33-3x (33-30 to 33-39, 33-3A to 33-3F): Short to Another Wire or Decreased Resistance in Left Side Curtain Airbag InflatorSpecial Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead E 07XAZ-S1A0200
- SRS short canceller 070AZ-SAA0100
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on, and is DTC 33-3x indicated?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Diagnostic Strategies If another DTC is indicated, go to the DTC Troubleshooting Index. DTC List - Supplemental Restraint System
3. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
4. Disconnect the left side curtain airbag 2P connector (A) from the floor wire harness (B).
5. Connect the SRS inflator simulator (2 Ohm connector) and simulator lead E to the floor wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTC 33-3x indicated?
YES - Go to step 9.
NO - Short to another wire in the left side curtain airbag inflator; replace the left side curtain airbag.
9. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
10. Disconnect SRS unit connector C (28P) from the SRS unit.
11. Disconnect the SRS inflator simulator from the SRS simulator lead.
12. Connect the SRS short canceller (070AZ-SAA0100) to the No. 7 and No. 8 terminals of SRS unit connector C (28P).
13. Check resistance between the terminals of the SRS simulator lead. There should be an open circuit or at least 1 MOhm.
Is the resistance as specified?
YES - Faulty SRS unit or poor connection at SRS unit connector C (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit.
NO - Short to another wire in the floor wire harness; replace the floor wire harness.