Shift Arm/Gear Selector Arm

1. Check shift arm-to-shift rod guide clearance.

Standard (New): 0.05-0.35 mm (0.002-0.01 in.)
Service Limit: 0.8 mm (0.03 in.)

2. If not within service limit, measure width of slot in shift rod guide.

Standard (New): 11.8-12.0 mm (0.46-0.47 in.)

3. If slot is wider than standard, replace shift rod guide.




1. Check selector arm-to-shift rod guide clearance.

Standard (New): 0.05-0.25 mm (0.002-0.01 in.)
Service Limit: 0.5 mm (0.02 in.)

2. If not within service limit, measure width of tab on selector arm.

Standard (New): 11.9-12.0 mm (0.469-0.472 in.)

3. If tab is narrower than standard, replace the arm.