TDC/Crank Sensor

Fig. 41 Removing TDC & CRANK rotors:

Fig. 42 Installing TDC & CRANK rotors:

1988 Prelude
1. Remove distributor. Refer to ``Electronic Ignition'' section.
2. Remove distributor cap from distributor housing.
3. Using two screwdrivers, carefully pry up TDC and CRANK rotors, Fig. 41, being careful not to damage rotors.
4. Remove TDC/CRANK coil assembly.
5. Install new TDC/CRANK coil assembly on distributor housing.
6. Install TDC and CRANK rotors, Fig. 42, with part numbers facing up.
7. Install distributor cap to distributor housing.
8. Install distributor. Refer to ``Electronic Ignition'' section.