Ignition Switch: Service and Repair

Electrical Switch Replacement





SRS wire harness is routed near the ignition switch.

CAUTION:
^ All SRS electrical wiring harnesses are covered with yellow outer insulation.
^ Before disconnecting the SRS wire harness, install the short connector on the airbag.
^ Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

1. Remove the steering wheel, then remove the steering column covers.
2. Disconnect the 7-P connector from the under-dash fuse box.
3. Insert the key and turn it to "0."
4. Remove the 2 screws and replace the base of the switch.