Shift Interlock Solenoid: Testing and Inspection

1. Remove instrument panel lower cover and knee bolster.
2. Remove steering column upper and lower covers.
3. Disconnect shift lock solenoid 2-P connector.

Fig. 13 Shift Lock Solenoid Test Terminal:

4. Connect battery power momentarily to No. 1 terminal of shift lock solenoid, Fig. 13, noting the following:
a. Ensure power is not applied to terminal No. 2, as the solenoid will be shorted out.
b. Ensure shift lock stop does not protrude when in On position.
c. Ensure shift lock stop does protrude more than 0.30 inches when Off.
5. Check that shift lock releases when release lever is pushed.
6. Check that shift lock solenoid locks when lever is released.
7. If solenoid does not work as outlined, replace.