Impact Sensor: Service and Repair

1. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
2. When replacing lefthand side sensor, remove foot rest and door sill molding, then pull back carpet.
3. When replacing righthand side sensor, remove foot rest and door sill molding, then pull back carpet. Remove fuel injection ECM.

Fig. 35 Dash Sensor Mounting:

4. On either sensor, remove sensor mounting bolts, then the sensor, Fig. 35.
5. Reverse procedure to install, noting the following:
a. Tighten dash attaching bolts to specifications.
b. After completing installation, place ignition switch in On position. SRS indicator lamp should be illuminated for approximately six seconds, then lamp should turn off. If lamp remains illuminated or does not illuminate, a problem in the SRS is indicated.
6. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.