Removal and Installation/Replacement

NOTE: Remove the alternator from below the vehicle.

1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons ('99 - 00 models).
2. Remove the battery negative cable, then disconnect the positive cable.




3. Disconnect the 4P or 3P connector from the alternator.
4. Remove the terminal nut and the WHT wire from the B terminal.




5. Remove the adjusting bolt and through bolt nut, then remove the alternator belt from the pulley.
6. Pull out the alternator through bolt, then remove the alternator.
7. If necessary, remove the mount bracket bolts, and the upper and lower mount brackets.
8. Adjust the alternator belt tension after installation.
9. Enter the anti-theft code for the radio, then enter the customer's radio station presets ('99 - 00 models).