Power Door Lock Control Module: Testing and Inspection

Control Unit Input Test / Without Keyless Entry System

1. Remove the driver's door panel.
2. Disconnect the 12P connector from the control unit.




3. inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, make the input tests shown in the table at the connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the control unit must be faulty; replace it.




Disconnect the 12P connector from the power door lock control unit.

CAUTION: To prevent damage to the actuator, apply battery voltage only momentarily.




Reconnect the 12P connector to the power door lock control unit.